They are formed through various chlorination processes whereby at least one chlorine anion (Cl-) is covalently bonded to the relevant metal or cation. Chloride materials can be decomposed by electrolysis to chlorine gas and the metal. Chloride compounds can conduct electricity when fused or dissolved in water. Sodium Chloride is an excellent water soluble crystalline Sodium source for uses compatible with chlorides. LICENSED GRANTED TO MAKE UNLIMITED PAPER COPIES FOR INTERNAL USE ONLY. See reverse side of invoice or packing slip for additional terms and conditions of sale. American Elements shall not be held liable for any damage resulting from handling or from contact with the above product. It does not represent any guarantee of the properties of the product. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions. The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. Safety Data Sheet according to Regulation (EC) No. Contact your local waste disposal authority for advice, or pass to a chemical disposalĬLASSIFICATION: Not classified as dangerous according to EC directives EC-No.:231-598-3 No environmental hazard is anticipated provided that the material is handled and disposed of with due care and attention.ĭISPOSAL METHODS: Non hazardous and non-regulated solid waste. TOXICOLOGICAL FINDINGS No evaluation of toxicological data is available. MUTAGENICITY/TERATOGENICITY No evidence of mutagenic effects. STABILITY: Stable under normal conditions of storage or use.ĬARCINOGENICITY No evidence of carcinogenic properties. SOLUBILITY IN WATER: Very soluble (35.7g/100g water at 0☌) PH IN AQUEOUS SOLUTION: No data available PHYSICAL AND CHEMICAL PROPERTIESĪPPEARANCE : Clear transparent crystalline pieces Should be sought before employing on tasks involving exposure to this material.ĮXPOSURE LIMITS OES, not assigned (Long term, 8 hour TWA) For persons with sensitive existing medical conditions, medical advice When handling quantities of this material, be sure to wear appropriate protective equipment as described. Provide adequate general mechanical ventilation, and Respirators must be worn when the threshold limit is exceeded. There is any possibility of chipping or dust creation. Safety goggles or safety glasses with side shields are required if Protective gloves made of polyvinyl alcohol (PVA) are required. Keep well closed and protected from moisture. STORAGE PRECAUTIONS: Store at room temperature (15 to 25☌ recommended). USAGE PRECAUTIONS: No special precautions Any residues should be treated as for small spillages. Sand or earth and both liquids and solids transfered to salvage containers. For large spillages liquids should be contained with Wash site of spillage thoroughly with water and detergent. Mix with sand, transfer carefully toĬontainer and arrange removal by disposal company. UNUSUAL FIRE HAZARDS: May evolve toxic fumes in a fire.ĬONTAMINATION CLEANUP: Wear suitable protective clothing & equipment as listed under Exposure / Personal protection. Obtain medical attention.įLASH POINT: Not Ignitable. INGESTION: Wash out mouth thoroughly with water. INHALATION: Remove from exposure, rest and keep warm. SKIN: Wash off thoroughly with soap and water. GENERAL: Consult a Physician for specific adviceĮYES: Irrigate thoroughly with water, if discomfort persists obtain medical attention. COMPOSITION/INFORMATION ON INGREDIENTSĬOMPONENT NAME CAS No. Not classified as dangerous according to EC directives. Relevant identified uses of the substance: Scientific research and development Product Number: All applicable American Elements product codes, e.g. Thin Film Deposition & Evaporation Materials.Additive Manufacturing & 3D Printing Materials.
0 Comments
Leave a Reply. |